LG Washer UE Error: Unbalanced load
LG washer error — here’s what you need to know. The UE error code on your LG washing machine indicates Unbalanced Load Detected. This is a Low severity issue. What Does UE Mean on an LG Washer? The UE code means the washer detected that its drum load is unevenly distributed during the spin cycle. […]
~90%
DIY Fixable
From 5
Typical Repair Cost
5 – 20 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. The UE error is a safety pause, not a mechanical failure. It is safe to continue using the washer once the load is redistributed.
Can I reset the code?
Yes. Redistribute the laundry, close the door, and press Start/Pause to resume. If the cycle cannot be resumed, press Power to cancel and restart a new spin cycle.
When to stop immediately?
Stop if you notice: The drum is visibly wobbling or striking the cabinet on every spin attempt regardless of load size., UE appears consistently even with small, evenly distributed loads..
Symptoms You May Notice
Washer stops mid-spin and starts tumbling again
The machine pauses its spin cycle, adds a small amount of water, and attempts to redistribute the load by tumbling slowly.
Loud thumping or banging during spin
An off-balance drum strikes the cabinet walls, producing heavy thumping noises as the drum tries to reach high spin speeds.
UE code displayed and cycle halted
After multiple failed rebalance attempts the washer stops and shows UE on the display, requiring user intervention.
Cycle interruption or early shutoff
The washer stops mid-cycle or shuts off before completing the programmed operation, requiring a manual restart or reset to attempt the cycle again.
Possible Causes
Tangled or balled-up items
Heavy items like jeans or towels can clump together on one side of the drum, creating a severe weight imbalance.
DIY PossibleOverloaded or underloaded drum
Too many items prevent free movement; too few items (especially one large piece) cannot distribute weight evenly.
DIY PossibleWorn suspension rods or shock absorbers
Aged suspension components lose their damping ability, allowing the drum to swing excessively even with a properly loaded tub.
Requires ProfessionalSafe Checks You Can Do
-
1
Open and redistribute the load
Open the washer door, pull items apart by hand, and spread them evenly around the drum. Close the door and restart the spin cycle.
-
2
Check load size
Remove excess items if the drum is packed full, or add a couple of similar-weight items if washing just one large piece (e.g., add a towel with a comforter).
-
3
Verify the washer is level
Use a bubble level on top of the machine. Adjust the front leveling legs by turning them clockwise to raise or counter-clockwise to lower until the machine sits perfectly level on all four corners.
When to Call a Professional
Contact a qualified technician if:
- Suspension rods are visibly bent, cracked, or missing their plastic cups when you look inside the cabinet.
- The drum moves more than 1 inch side-to-side when pushed by hand with the machine empty.
- Error persists after leveling the machine and washing with a properly balanced load multiple times.
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Washer Repair Service Schedule Appointment